Introduction to the structure and operation points of the high temperature dyeing jigger

The main structure:

Rolling stick:

The central arrangement of the dyeing jigger is two replacement rolls of the reciprocating rewinding machine. The fabric is unwound from one roll and rolled onto the other roll. During the process of replacing the rewinding machine, continue Skip the dyeing solution under the cloth rolling stick, digest and absorb the dyeing solution onto the nylon fabric, and absorb, fuse and contact it during the whole process of rewinding machine.

Dyeing machine:

Also known as the dyeing tank, it is located under the cloth rolling rod and contains the dyeing liquid. The cloth in the rewinding machine skips under the liquid at the bottom of the dyeing machine.

Transmission gear differential protection arrangement:

A method that stabilizes the angular velocity of the two rolling sticks, and is not prone to elastic wrinkling due to fast feeding and slowing down when based on the fabric width, and will not cause excessive support force, elongation or even lengthening due to slow feeding and fast retraction* Mechanical equipment for tearing fabric.

cylinder head:

The cylinder head of the jigger at room temperature has the effect of stabilizing the left and right, upper and lower temperatures inside the cylinder, preventing the fabric on the liquid from being blown gently by the wind and causing heat dissipation to cause power damage, and also preventing the dye from entering and contacting due to the low temperature at the upper end inhibition. The cylinder head of the high-temperature and high-pressure dyeing machine has the function of a pressure cover, and the temperature inside the machine cylinder exceeds 100°C, which is suitable for dyeing polyester fabrics with disperse dyes.

Operation points:

1. Chemicals: The dye must be stirred and melted in the chemical tank before it can be injected into the machine tank, otherwise the nylon fabric is likely to cause color lake stains

2. Temperature: It is necessary to cover the heat insulation and heat preservation operation to keep the temperature of the upper and lower parts of the main cylinder of the machine consistent.

3. Raise the temperature: When adding steam to raise the temperature, the cloth roll cannot be operated, otherwise the temperature difference between the front and back will form a color cast

4. Head and tail: Before operation, the difference between the temperature of the cloth roll and the temperature of the liquid should be small. In winter, it is necessary to prevent the cloth roll from being too cold so that the cloth layer that touches the roll is cooled. It can be poured with hot dyeing liquid several times. Rolling makes it raise the temperature.