Precautions when using high temperature and high pressure dyeing machine
Oct 16, 2021
When using high-temperature and high-pressure dyeing machine equipment, it is also necessary to pay attention to the time when dyes are selected. On a large scale, we should actually try our best to select materials with dispersibility and uniformity. In this way, it will actually be more reliable when splicing. It is precisely because of this that when we are using it, we can actually make better use of it to a large extent. Advantages in all aspects.
Next, in fact, it also refers to the time when the high-temperature and high-pressure dyeing machine is operating. We should actually perform a series of reduction and cleaning. However, in terms of this process, it will actually cause The color and luster of the material will also be affected. In this respect, these are actually relatively normal phenomena. In view of this, we don't need to worry too much.
Next, when using the high temperature and high pressure dyeing machine in actual production, we must pay attention to when we use its tar, we must avoid spots on it.
Speaking of the reason, it is actually due to the fact that this will result in the formation of a thicker substance near the oil. When the high temperature and high pressure dyeing machine is in such a situation, some fibers will be directly infiltrated from the fiber. , In this way, as far as its processing and application of high temperature and high pressure dyeing machine are concerned.
Preparation of the dye solution When preparing the dye solution, first use a small amount of cold water to make the dye into a paste, and then dilute it with room temperature water. Note that the temperature of the diluting water should not be too high, higher than 60 degrees, the disperse dye quilt will be destroyed and agglomerate In addition to the above modulation, the dye can also be prepared by dusting method, that is, gradually sprinkle the dye into cold water under high-speed stirring. It is not suitable to leave the dye bath for a long time after preparation. The same feed needs to be gradually stirred with a stirrer to avoid deposits.