Dyeing points of Jigger Dyeing Machine

Dyeing on the Jigger Dyeing Machine is a wide range of dyeing machinery and equipment, suitable for dyeing woven fabrics with immediate, vulcanized rubber, specific, rejuvenating, dispersing, acid-base and other dyes, and it can also carry out decompression/boiling. /Solution before bleaching, the main purpose is wider, the structure is simple, the maintenance is convenient, and the project investment is small, especially in the sales market situation that is suitable for today's small batch production, multiple types, and fast delivery. Up to now, there are 4 types:

①General differential protection uniform speed Jigger Dyeing Machine

②Differential protection uniform speed Jigger Dyeing Machine

③Ultra high pressure Jigger Dyeing Machine

④ Roll up Jigger Dyeing Machine

Each axis can dye up and down 4000m. Except for the large quantity, the basic principle and operation steps of dyeing are basically similar. Strictly speaking, they are a kind of fully automatic assembly line dyeing machine equipment. If you want to dye a good color on the Jigger Dyeing Machine, it usually depends on the proficiency of the actual operation.

Generally speaking, the following key points should be grasped:

(1) The side of the inlet cylinder should be neat. Regardless of the type of Jigger Dyeing Machine you want to use for dyeing fabrics, you need to pull out a piece of fabric on the upper side of the fabric before pushing down the cylinder, and the fabric is facing outward to the guide roller to prevent it from being The dead roll is scratched, and then pass the spreading roll and the bottom guide roll (on the top of the steam pipe) from one side, wrap it on the opposite cross roll, and then roll the fabric into the cylinder in the center, with a piece of connecting head cloth wrapped around it. On the cross roller on the side of the cloth. However, regardless of the wet wipes or dry grey cloths that have been solved before, they need to be kept neat on one side, and there will be some bumps (roughness) on the other side. It is all normal, but it is not allowed to be uneven on both sides. Secondly, set up automatic U-turn (phase change) and counting equipment, drive the car to return the entangled fabric (1 lane), depending on the situation, you can drain the residual liquid in the tank and replace it with new liquid. Requires bath ratio. Generally, the temperature of the vacant bath in the tank is raised to 40. At C, the feeding is carried out according to the processing technology regulations.

(2) Melt the dyestuffs separately and feed them evenly on both sides. To add all the dyestuffs in Jigger Dyeing Machine, you need to pay attention to:

① If you are not proficient, be sure to shut down and feed, and do not add while walking;

②All dyestuffs need to be melted and prepared beforehand;

③When adding, it needs to be divided into two and added on both sides. After each side is filled, it is necessary to use bamboo, wood or stainless steel rods to make it evenly balanced, and use appropriate residues on the sides of the tank. Wash the water into the tank to keep the production clean and cultivate good practical operation habits.