Introduction to the structure and operation points of the HT Jigger Dyeing Machine

The main structure:

Rolling stick:

The management center of Jigger Dyeing Machine is organized by 2 reeling rollers that replace the rewinding machine. The fabric is unwound from one reeling roller and rolled to the other reeling roller. During the whole process of replacing the rewinding machine, continuous It crosses the dyeing liquid under the cloth roll, digests and absorbs the dyeing liquid onto the nylon fabric, and absorbs, fuses, and inhibits contact during the whole process of the rewinding machine.

Dyeing machine:

Also called the dyeing tank, it is located under the cloth roll and holds the dyeing liquid.

Transmission gear differential protection organization:

A method that stabilizes the angular velocity of the two cloth rolls, and is not easy to stretch and wrinkle due to fast supply and slow retraction when the fabric is based on the open width, and will not cause excessive support, lengthening or even pulling due to slow supply and fast retraction. Mechanical equipment for breaking fabrics.

Cylinder head:

Under normal temperature, the cylinder head of Jigger Dyeing Machine has the effect of stabilizing the left and right and up and down temperatures inside the cylinder, avoiding the damage to the power and energy caused by the heat exhaust of the fabric on the liquid surface, and also avoiding the infiltration and contact of dyes due to the low temperature of the upper end. The cylinder head of the HTHP Jigger Dyeing Machine has the function of a working pressure cover. The temperature inside the cylinder exceeds 100℃, and it is suitable for disperse dyeing polyester fabrics.

Operation points:

1. Chemicals: dyes are essential. Now, the dyes must be fully mixed and melted in the chemical tank before they can be put into the machine cylinder, otherwise the nylon fabric is likely to cause lake stains

2. Temperature: It is necessary to cover the heat insulation operation to maintain the same temperature of the upper and lower parts of the main tank.

3. Warming: When adding steam to warm, the cloth roll cannot be operated, otherwise the temperature difference between the front and rear, left and right will cause color cast.

4. First and last: The temperature of the cloth roll should be applied before operation and the difference between the temperature under the liquid is not large. In winter, it is necessary to avoid the cloth roll being too cold to reduce the temperature of the cloth layer touching the roll, and it can be poured several times with hot dyeing liquid. The rolls allow it to raise its temperature.