Jigger Dyeing Machine type development

The early Jigger Dyeing Machine was made of wood and iron, and gradually adopted stainless steel in the late 1970s. According to the different types of fabrics processed, Jigger Dyeing Machine has three types: open, capped, high temperature and high pressure, etc. Now the exposed equipment has basically been eliminated. The stamped Jigger Dyeing Machine is mainly used for dyeing silk and cotton cloth, and the high temperature and high pressure Jigger Dyeing Machine is used for dyeing polyester, nylon and other synthetic fiber fabrics. Also known as dye vat and machine vat. The open-width intermittent dyeing equipment is used for the dyeing of silk, cotton, and chemical fiber cloths that require a flat appearance in small batches, as well as the scouring and fixation processes before and after dyeing. The high-temperature and high-pressure automatic Jigger Dyeing Machine is suitable for the high-temperature and high-pressure dyeing of various thick and thin chemical fiber fabrics, as well as the dyeing of various natural and blended fabrics at room temperature and pressure. 1. Chemical material: The dye must be fully stirred and dissolved in the chemical material tank before it can be driven into the cylinder, otherwise lake stains may occur on the cloth surface. 2. Temperature: It must be covered for heat preservation operation to maintain the same temperature everywhere in the cylinder above and below the liquid. 3. Heating up: Do not run the cloth roll when the steam is heating up, otherwise the temperature difference between front and rear will cause color difference. 4. Head and tail: Before running, it is necessary to keep the temperature of the cloth roll and the temperature under the liquid not much different. In winter, it is necessary to prevent the cloth roll from being too cold to cool down the cloth layer contacting the roll. Hot dye solution can be used to pour the roll several times. To increase the temperature.